Shift Lever: Installation

WARNING: This page is about a different car, the 2011 Hyundai Elantra Touring. However, it is still accessible from the selected car via links, so may be relevant.

Install the retainer (A) and nuts (B).
Tightening torque:

12-15 Nm (1.2-1.5 kgf.m, 8.7-10.8 lb-ft)

NOTE: In case, install the crush pad and cowl cross bar. (refer to CRUSH PAD and HEATER UNIT )

Fig 1: Identifying Retainer And Nuts
Courtesy of HYUNDAI MOTOR CO.
Install the shift lever assembly (A).
Tightening torque:

9-14 Nm (0.9-1.4 kgf.m, 6.5-10.1 lb-ft)

Fig 2: Identifying Shift Lever Assembly
Courtesy of HYUNDAI MOTOR CO.
Connect the interlock switch connector (A).

Fig 3: Identifying Interlock Switch Connector
Courtesy of HYUNDAI MOTOR CO.
Install the shift cable assembly (B) by installing the clamp (A).

Fig 4: Identifying Shift Cable Assembly And Clamp
Courtesy of HYUNDAI MOTOR CO.
Install the center console, (refer to CONSOLE )
Install the center console cover (A).

Fig 5: Identifying Center Console Cover
Courtesy of HYUNDAI MOTOR CO.
Install the shift lever knob (A).

Fig 6: Identifying Shift Lever Knob
Courtesy of HYUNDAI MOTOR CO.
Install the shift cable assembly to transaxle. (refer to INSTALLATION )

NOTE: Before completing installation, adjust the shift cable referring to ADJUSTMENT section.