Power Door Lock Switch: Service and Repair

Inspection

Diagnosis With GDS
1. It will be able to diagnose defects of DDM/ADM with GDS quickly. GDS can operates actuator forcefully, input/output value monitoring and self diagnosis.
2. Select model and "IPM".
3. Select the "DDM" to check.
4. Select "Input/output monitoring", if you will check current data of power door lock system. It provides input/output status of DDM/ADM.




5. If you will check the power door lock operation forcefully, select "Actuation test".




6. To check the DTC of the DDM/ADM module, select "Diagnostic trouble codes"






Removal

1. Disconnect the negative(-) battery terminal.
2. Remove the front door trim panel.

3. Disconnect the power window switch module connector (A) from the wiring harness.




4. Remove the power window switch module (B) from the door trim after loosening the mounting screws.

Installation

1. Install the power window switch module.
2. Install the door trim panel after reconnecting the relevant connectors

NOTE:
- Make sure that the power window switch module connectors are plugged properly.
- Check that the power window switch and door lock switch operate normally.