Repair procedures

Replacement

1. Remove the rear door window glass.

2. Remove the rear door outside handle.

3. After loosening the mounting screws, then remove the rear door belt outside weatherstrip (A).




4. Loosen the rear door channel mounting bolt and nuts.

Tightening torque :
3.9 - 5.9 N.m (0.4 - 0.6 kgf.m, 2.9 - 4.3 lb-ft)




5. Remove the rear door channel (A).




6. Loosen the outside handle base mounting bolt (A).




7. Loosen the rear door latch (B) mounting screws.
8. After loosening the mounting bolts, then remove the rear door module (A).

Tightening torque :
6.9 - 10.8 N.m (0.7 - 1.1 kgf.m, 5.1 - 8.0 lb-ft)




9. Disconnect the rear door module mounting clip (B).
10. Disconnect the connectors and rear door module wiring harness (A).




11. Install in the reverse order of removal.

CAUTION:
- The area of whole parts should be applied with sufficient grease.
- Make sure connectors are connected properly and each rod is connected securely.
- Make sure the door locks/unlocks and opens/closes properly