Repair Procedures: Replacement

NOTE:

Put on gloves to protect your hands.
Use seat covers to avoid damaging any surfaces.

Remove the following items.
1. Tail gate frame upper trim & Tail gate center trim
  Refer to TAIL GATE .
2. Tail gate trim
  Refer to TAIL GATE .
3. Tail gate frame side trim
  Refer to TAIL GATE .
4. Tail gate glass heater connector
  Refer to REAR GLASS DEFOGGER PRINTED HEATER .
5. Rear wiper arm
  Refer to REMOVAL .
Disconnect the washer nozzle (B) and high mounted stop lamp connector (A).

Fig 1: Identifying Washer Nozzle And High Mounted Stop Lamp Connector
Courtesy of HYUNDAI MOTOR AMERICA
Loosen the rear spoiler mounting nuts.
Tightening torque:

5.9 ~ 6.4 N.m (0.6 ~ 0.65 kgf.m, 4.3 ~ 4.7 lb-ft)

Fig 2: Identifying Rear Spoiler Mounting Nuts
Courtesy of HYUNDAI MOTOR AMERICA
Remove the rear spoiler (A).

Fig 3: Identifying Rear Spoiler Mounting Nuts
Courtesy of HYUNDAI MOTOR AMERICA
Spread the WD-40 on the side of tail gate glass.
Cut out the adhesive using the cutter (A).
NOTE:
- Please use the cutter with a blade length between 8-12 inches.
[Front]

Fig 4: Cutting Adhesive Using Cutter (Front)
Courtesy of HYUNDAI MOTOR AMERICA

[Rear]

Fig 5: Cutting Adhesive Using Cutter (Rear)
Courtesy of HYUNDAI MOTOR AMERICA
Enough on the upper, lower, side of tail gate glass. and then cut out the adhesive using the cutter tool (09861-31100).
[Front]

Fig 6: Identifying Adhesive Applying Area (Front)
Courtesy of HYUNDAI MOTOR AMERICA

[Rear]

Fig 7: Identifying Adhesive Applying Area (Rear)
Courtesy of HYUNDAI MOTOR AMERICA
Remove the tail gate glass (A).
NOTE:
- When removing and installing the tail gate glass, an assistant is necessary.
[Front]

Fig 8: Identifying Tail Gate Glass (Front)
Courtesy of HYUNDAI MOTOR AMERICA

[Rear]

Fig 9: Identifying Tail Gate Glass (Rear)
Courtesy of HYUNDAI MOTOR AMERICA