Rear Power Window Switch Inspection

Disconnect the negative (-) battery terminal.
Remove the rear door trim.
(Refer to the REAR DOOR .)
Remove the rear power window switch module (A).

Fig 1: Identifying Seat Heater & Rear Power Window Switch Connector Terminals
Courtesy of HYUNDAI MOTOR CO.
Check for continuity between the terminals in each switch position according to the charts below. If the continuity condition is not normal, replace the switch.
[Seat Heater]

Fig 2: Identifying Seat Heater Switch Connector Terminals
Courtesy of HYUNDAI MOTOR CO.

[General]

Fig 3: Rear Power Window Switch Connector Terminals Continuity Chart (General)
Courtesy of HYUNDAI MOTOR CO.