Passenger Power Window Switch Inspection

Disconnect the negative (-) battery terminal.
Remove the front door trim panel.
(Refer to: BD procedure - "FRONT DOOR ").
Disconnect the connector from the switch.

Fig 1: Passenger Power Window Switch Connector Terminal
Courtesy of HYUNDAI MOTOR AMERICA
Check for continuity between the terminals in each switch position according to the table. If the continuity condition is not normal, replace the switch.
[Without Lock]

Fig 2: Passenger Power Window Switch Terminal Continuity Chart (Without Lock)
Courtesy of HYUNDAI MOTOR AMERICA

[With Lock]

Fig 3: Passenger Power Window Switch Terminal Continuity Chart (With Lock)
Courtesy of HYUNDAI MOTOR AMERICA