LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2015 >> Veloster Base, Automatic DCT Trans >> Repair and Diagnosis (Single Page) >> Engine Performance >> Engine Control Systems >> Engine Control System - 1.6L GDI >> Crankshaft Position Sensor (CKPS) >> Repair Procedures >> Removal
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Repair Procedures: Removal

  1. Turn the Ignition Switch OFF and disconnect the Battery Negative (-) Cable.
  2. Disconnect the Crankshaft Position Sensor Connector (A) and remove the Sensor (B) after removing the Installation Bolt.
    Fig 1: Crankshaft Position Sensor Connector And Installation Bolt
    G10607933Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals