Repair Procedures: Removal
- Remove the rear wheel and tire.
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
- Remove the rear wheel speed sensor mounting bolt (A).
Tightening torque:
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 7.6 lb-ft)
- Remove the rear seat back.
(Refer to "REAR SEAT ")
- Disconnect the rear wheel speed sensor connector.
- Installation is the reverse of removal.
CAUTION:
Install the rear sensor after lubricating the O-ring of sensor with the assembly fluid(RAREMAX AF-1).
When inserting the sensor, take care the O-ring not to be damaged.
When inserting the sensor, take care the O-ring not to be damaged.