LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2016 >> Elantra Value Edition >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Driveshaft Assembly) >> BJ Boot >> Repair Procedures >> Replacement
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair Procedures: Replacement

WARNING: This page is about a different car, the 2016 Hyundai Elantra GT and 2015 Hyundai Elantra GT. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front driveshaft.

    (Refer to "FRONT DRIVESHAFT ")

  2. Remove the TJ joint assembly.

    (Refer to "TJ JOINT ")

  3. Remove the Dynamic damper.

    (Refer to "DYNAMIC DAMPER ")

  4. Using a plier or flat-tipped (-) screwdriver, remove the BJ boot bands (A).
    Fig 1: Removing BJ Boot Bands
    G10750339Courtesy of HYUNDAI MOTOR AMERICA
  5. Remove the BJ boot.
  6. Install in the reverse order of removal.
    CAUTION:
    • Do not disassemble the BJ assembly.
    • Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease.
    • The boot band should be replaced with a new one.
scientia non olet · About LEMON Manuals