Repair procedures: Installation

WARNING: This page is about a different variant/trim than selected.

Install in the reverse order of removal.
NOTE:
- When installing, set control shaft lever to neutral position.
  
  Fig 1: Control Shaft Lever
  Courtesy of HYUNDAI MOTOR AMERICA
- When installing, apply the sealant as shown in Fig 2.
  Specified sealant: MS 721-40 or MS721-38
  
  Fig 2: Control Shaft Assembly Sealant Applying Area
  Courtesy of HYUNDAI MOTOR AMERICA
After installing, check to be sure that this part operates as designed at each range of T/M side corresponding to each position of shift lever.