Repair Procedures: Installation

Check that the shift lever is placed in the "N" position
Lightly tighten the inhibitor switch mounting bolts (B) after installing the inhibitor switch (A).

Fig 1: Identifying Inhibitor Switch And Mounting Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Lightly tighten the manual control lever mounting nut (A) after installing the manual control lever (B).

Fig 2: Identifying Manual Control Lever And Mounting Nut
Courtesy of HYUNDAI MOTOR AMERICA
Align the hole (A) in the manual control lever with the "N" position hole (B) of the inhibitor switch and then insert the inhibitor switch guide pin (SST No.: 09480-A3800).

Fig 3: Inserting Inhibitor Switch Guide Pin (SST No. 09480-A3800)
Courtesy of HYUNDAI MOTOR AMERICA
Tighten the nut (A) and bolts (B) with the specified torque.
Tightening Torque:

(A): 17.7 ~ 24.5 N.m (1.8 ~ 2.5 kgf.m, 13.0 ~ 18.1 lb-ft)

(B): 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Fig 4: Identifying Nuts And Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Lightly tighten the nut (B) after connected the shift cable (C) in the manual control lever (D).
Push shift cable (C) lightly to "F" direction displayed to eliminate free play of shift cable.
Tighten the nut (B) with the specified torque.
Tightening Torque:

9.8 ~ 14.7 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft)

Fig 5: Identifying Shift Cable, Manual Control Lever, Nut And Inhibitor Switch Guide Pin (SST No.: 09480-A3800)
Courtesy of HYUNDAI MOTOR AMERICA
Remove the inhibitor switch guide pin (SST No.: 09480-A3800) from the hole.
Connect the inhibitor switch connector (A).

Fig 6: Identifying Inhibitor Switch Connector
Courtesy of HYUNDAI MOTOR AMERICA
Install the Battery and Battery tray.
(Refer to: Engine Electrical System - "BATTERY ").
Connect the Battery negative (-) cable.
CAUTION:
- Check that operating surely at each range of the inhibitor switch corresponding to each position of shift lever.