LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2016 >> Veloster Base, Standard Trans >> Repair and Diagnosis >> Drivelines & Axles >> Wheel Hubs >> Front Axle Assembly >> Front Hub Knuckle >> Repair Procedures >> Reassembly
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair Procedures: Reassembly

  1. Install the Hub Bearing to the Knuckle Assembly.
    1. Lay the Knuckle Assembly (A) on a Press.
    2. Lay a new Hub Bearing upon the Knuckle Assembly (A).
    3. Lay a Suitable Adapter (B) upon the Hub Bearing.
    4. Install the Hub Bearing to the knuckle assembly by using press.
      Fig 1: Installing Hub Bearing To Knuckle Assembly
      G10604763Courtesy of HYUNDAI MOTOR AMERICA
      CAUTION:
      • Do not press against the inner race of the hub bearing because that can cause damage to the bearing assembly.
      • Always use a new wheel Bearing Assembly.
  2. Install the Hub Assembly to the Knuckle Assembly.
    1. Lay the Hub Assembly (A) upon a Suitable Adapter (C).
    2. Lay the Knuckle Assembly (B) upon the Hub Assembly (A).
    3. Lay a Suitable Adapter (C) upon the Hub Bearing.
    4. Install the Hub Assembly (A) to the Knuckle Assembly (B) by using a Press.
      Fig 2: Installing Hub Assembly To Knuckle Assembly
      G10604764Courtesy of HYUNDAI MOTOR AMERICA
      CAUTION: Do not press against the inner race of the hub bearing because that can cause damage to the bearing assembly.
  3. Install the Snap Ring (A).
    Fig 3: Installing Snap Ring
    G10604765Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals