LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2017 >> Accent Value Edition >> Repair and Diagnosis >> External Pages >> Different car >> Section 67 (Supplemental Restraint System Control Module (SRSCM) And Sensors) >> SRS Control Module (SRSCM) >> Repair Procedures >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair Procedures: Removal

WARNING: This page is about a different car, the 2017 Hyundai Santa Fe Sport. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the ignition key from the vehicle.
  2. Disconnect the battery negative cable and wait for at least three minutes before beginning work.
  3. Remove the floor console.

    (Refer to Body - "FLOOR CONSOLE ")

  4. Loosen the bolts and then remove the rear air vent duct (A).
    Fig 1: Removing Rear Air Vent Duct
    G12056263Courtesy of HYUNDAI MOTOR AMERICA
  5. Pull up the lock, of the SRSCM connector, then disconnect the connector (A).
    Fig 2: Disconnecting SRSCM Connector
    G12056264Courtesy of HYUNDAI MOTOR AMERICA
  6. Remove the SRSCM mounting bolts (3 EA) from the SRSCM, then remove the SRSCM.
    CAUTION: You must remove or install SRSCM or other SRS components with the ignition switch OFF to avoid accidental airbag deployment.
scientia non olet · About LEMON Manuals