Repair Procedures: Replacement

CAUTION:

Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
Put on gloves to protect your hands.

Remove the rear seat assembly.
(Refer to Rear Seat - "Rear Seat Assembly ")
Disconnect the connectors (A), and mounting wiring clips (B).

Fig 1: Locating Mounting Wiring Clips And Connectors
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws, then remove the rear back armrest board (A).

Fig 2: Locating Rear Back Armrest Board With Mounting Screws
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting bolts, then remove the rear back armrest (A).

Fig 3: Locating Rear Back Armrest With Mounting Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Remove the rear back armrest board (A) after loosening the screws on the rear back armrest (B).

Fig 4: Locating Rear Back Armrest Board And Rear Back Armrest With Mounting Screws
Courtesy of HYUNDAI MOTOR AMERICA
Installation is the reverse of removal.
NOTE:
- Make sure the connectors are plugged in properly.