Repair Procedures: Installation

Remove the ignition key from the vehicle.
Disconnect the battery negative cable from battery and wait for at least three minutes before beginning work.
Place a passenger airbag on the crash pad and tighten the passenger airbag mounting bolts (A).
Tightening torque

: 3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

Fig 1: Locating Passenger Airbag Mounting Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Install the crash pad.
(Refer to Body - "MAIN CRASH PAD ASSEMBLY ")
Tighten the passenger airbag mounting bolts.
Tightening torque

: 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-.ft)
Connect the passenger airbag harness connector to the SRS main harness connector.
Reinstall the glove box housing.
(Refer to Body - "GLOVE BOX HOUSING ")
Reconnect the battery negative cable.
After installing the passenger airbag (PAB), confirm proper system operation:
- Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.