LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2017 >> Elantra GT Automatic Trans >> Repair and Diagnosis >> Engine Performance >> Ignition System >> Ignition Switch Assembly >> Repair Procedures >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair Procedures: Removal

  1. Disconnect the negative (-) battery terminal.
  2. Remove the driver crash pad lower panel.

    (Refer to "CRASH PAD LOWER PANEL ")

  3. Remove the steering column upper and lower shrouds.

    (Refer to "STEERING COLUMN SHROUD PANEL ")

  4. Remove the wiper switch.

    (Refer to "MULTIFUNCTION SWITCH ")

  5. Remove the ignition switch after disconnecting the ignition switch 6P connector.
  6. Remove the key warning/immobilizer connector (A).
    Fig 1: Locating Key Warning/Immobilizer Connector And Key Warning Switch Or Key Illumination
    G12077021Courtesy of HYUNDAI MOTOR AMERICA
  7. After loosening the screw, remove the key warning switch and key Illumination (B).
  8. Pushing lock pin with key ACC.
  9. Remove the key lock cylinder (A).
Fig 2: Locating Key Lock Cylinder
G12077022Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals