Repair Procedures: Removal

Remove the floor console assembly.
(Refer to "FLOOR CONSOLE ASSEMBLY ").
Remove the control cable (A).

Fig 1: Removing Control Cable
Courtesy of HYUNDAI MOTOR AMERICA
Remove the main crash pad.
(Refer to "MAIN CRASH PAD ASSEMBLY ").
Remove the heater unit.
(Refer to "HEATER UNIT ").
Remove the retainer (A) and nuts (B).
Tightening torque :

9.8 ~ 14.7 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft)

Fig 2: Removing Retainer And Nuts
Courtesy of HYUNDAI MOTOR AMERICA
Remove the nut (C).
Tightening torque :

9.8 ~ 13.7 N.m (1.0 ~ 1.4 kgf.m, 7.2 ~ 10.1 lb-ft)
Remove the cable (B) from the bracket (A) at transaxle assembly side.

Fig 3: Removing Cable From Bracket At Transaxle Assembly Side
Courtesy of HYUNDAI MOTOR AMERICA
Remove the control cable inside of cab.