Monitor GDS Data
WARNING: This page is about a different car, the 2019 Hyundai Elantra. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition switch "OFF"
- Ignition switch "ON"
- Connect GDS to Data Link Connector (DLC), and select correct variant code and press enter.
- Check any DTC stored in the system.
- Has any DTCs stored in the system?
YES
- Substitute with known-good BSD ECU and check for proper operation. If problem is corrected, replace BSD ECU and then, go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Fault is intermittent caused by faulty BSD ECU or was repaired and BSD ECU memory was not cleared.
Go to "VERIFICATION OF VEHICLE REPAIR " procedure.