Component Inspection
- Disassemble Fuel Level Sender with ignition switch turned 'OFF'.
- Measure resistance between signal terminal and ground terminal of Fuel Level Sensor with moving the float. (Component side)
Specification:
(Analog Gauge)
Float Position S/F 8/8 7/8 6/8 5/8 4/8 3/8 Sender Resistance (Ω) 15±1 20±1.5 32±1 45±1 62±1 82±1 108±2 Fuel remaining (L) 68.6 65.1 57.8 50.4 43.1 35.7 28.4 Float Position 2/8 1/8 Warning G/E S/E Sender Resistance (Ω) 142±2 188±3 233±3 255±3 300±3 Fuel remaining (L) 21 13.7 8.5 6.3 3 (Digal Gauge)
Float Position S/F 16/16 15/16 14/16 13/16 12/16 11/16 Sender Resistance (Ω) 15±1 20±1.5 26±1 32±1.5 38±1 45±1 53±1 Fuel remaining (L) 68.6 65.1 61.4 57.8 54.1 50.4 46.7 Float Position 10/16 9/16 8/16 7/16 6/16 5/16 4/16 Sender Resistance (Ω) 62±1 72±2 82±2 95±2 108±2 124±2 142±2 Fuel remaining (L) 43.1 39.4 35.7 32 28.4 24.7 21 Float Position 3/16 2/16 1/16 Warning G/E S/E Sender Resistance (Ω) 163±2 188±3 218 233±2 255±2 300±3 Fuel remaining (L) 17.3 13.7 10 8.5 6.3 3 - Is resistance within the specification?
YES
- Thoroughly check that any foreign material intrupts float moment. Erase DTC and drive the vehicle to satisfy the enable condition then, go to "Verification Of Repair " procedure.
NO
- Substitute with a known-good Fuel Sender and check for proper operation. If the problem is corrected, replace Fuel Sender and go to "Verification Of Repair " procedure.