Auto Cruise Switch
| Check Item | Specifications | Prerequisite condition | Terminal (+) | Terminal (-) |
|---|---|---|---|---|
| Resistance | Refer to the table below |
|
'Signal' and 'CRUISE MAIN' terminal of 'CRUISE REMOCON SWITCH' connector (Component side) with each switch depressed. 'Signal' and 'Ground' terminal of 'CRUISE REMOCON SWITCH' connector. (Component side) |
|
Specification:
| Item | Resistance (Ω) |
|---|---|
| SCC | 2.54 kΩ ± 5% |
| CRUISE | 880 Ω ± 5% |
| SET Switch | 330 Ω ± 5% |
| RESUME Switch | 550 Ω ± 5% |
| CANCEL Switch | 180 Ω ± 5% |
- Is the measured value within specification?
YES
- go to "Verification Of Repair " procedure.
NO
- Replace 'CRUISE REMOCON SWITCH' and go to "Verification Of Repair " procedure.
NOTE:
There is a memory reset function on GDS that can erase optional parts automatically detected and memorized by ECM. After testing ECM on the vehicle, use this function to reuse the ECM on the others.