(Position Sensor Removal And Installation)

ABBREVIATED PROCEDURE

Work		H/W	Tightening torque N.m (kgf.m/lb-ft)	SST/Equipment	Chemical	etc
Removal
1	Remove the air cleaner assembly (Refer to Engine Mechanical System - "AIR CLEANER ")	-	-	-	-	-
2	Remove the battery and battery tray (Refer to Engine Electrical System - "BATTERY ")	-	-	-	-	-
3	Disconnect the electronic shift actuator connector	-	-	-	-	-
4	Remove the electronic shift actuator after removing the bolts	Bolt	-	-	-	-
5	Disconnect the position sensor connector	-	-	-	-	-
6	Remove the position sensor after removing the bolts	Bolt	-	-	-	-
Installation
1	Check that the shaft is in the "N" position	-	-	-	-	-
2	Install the position sensor and then lightly tighten the bolts	Bolt	-	-	-	-
3	Install the position sensor "N" fixing SST (0K427-Q5100) and then tighten the bolts	Bolt	9.8 - 11.8 (1.0 - 1.2/7.2 - 8.7)	0K427-Q5100	-	-
4	Remove the position sensor "N" fixing SST (0K427-Q5100)	-	-	-	-	-
5	Connect the position sensor connector	-	-	-	-	-
6	Install the electronic shift actuator	Bolt	20.6 - 26.5 (2.1 - 2.7/15.2 - 19.5)	-	-	-
7	Connect the electronic shift actuator connector	-	-	-	-	-
8	Install the battery and battery tray (Refer to Engine Electrical System - "BATTERY ")	-	-	-	-	-
9	Install the air cleaner assembly and air duct (Refer to Engine Mechanical System - "AIR CLEANER ")	-	-	-	-	-
10	Check that operating surely at each range of the position sensor corresponding to each position of electric shift button	-	-	-	-	-