Power Circuit

Connect voltmeter positive lead to power side of indicated fuses and ground. See Fig 1 . Battery voltage should be present with ignition switch in position indicated in table. See TIME CONTROL SYSTEM POWER SUPPLY CHECK table.

TIME CONTROL SYSTEM POWER SUPPLY CHECK

Fuse No. & Ignition Switch		Battery Voltage
7
OFF		No
ACC		Yes
ON		Yes
23
OFF		Yes
ACC		Yes
ON		Yes
32
OFF		No
ACC		No
ON		Yes

Fig 1: Checking Time Control Unit Power Supply (J30)

Courtesy of NISSAN MOTOR CO., U.S.A.

NOTE: Hybrid Electric Control (HEC) unit uses two 16-pin connectors. Wires from 16-pin connector referenced in following step lead to engine compartment.