Remote Transmitter Programming (ITB93-068)

Publication date: 1993-12-16
Reference number: ITB93-068

REMOTE TRANSMITTER PROGRAMMING

TECHNICAL SERVICE BULLETIN

Reference Number(s): ITB93-068, Date of Issue: December 16, 1993

J30/G20/Q45 REMOTE TRANSMITTER PROGRAMING

Model(s): 1993-94 Infiniti J30

1993.5 Infiniti G20

1994 Infiniti Q45

Classification: EL93-015

Section: Electrical

Bulletin No.: ITB93-068

Date: December 16, 1993

SERVICE INFORMATION

The proper procedure for programing additional remote controllers is listed below.

SERVICE PROCEDURE

While sitting inside the vehicle:

Open the trunk.
Close and lock all doors.
Insert and remove the key from the ignition six times within 10 seconds.
Manually unlock and lock driver's door once to enable "Belting" mode.
Push lock button on the new remote controller once, just long enough to hear within 5 seconds of completing step 4.
If additional remotes are needed (up to 3), repeat steps 4 and 5 for each additional remote immediately after programming the first remote.

NOTE: A total of four (4) remotes can be programmed to function on the same vehicle. For additional information, please refer to page BF-38 of the 1993 and 1994 J30 Service Manuals: page BF-17 of the 1993 G20 Service Manual Supplement; and page EL-148 of the 1994 Q45 Service Manual.