Programming Remote Controller
NOTE:
New identity code must be entered whenever replacing or adding additional remote controller(s), or when replacing smart entrance control unit.
- Close and lock all doors. Erase original identity code(s) by inserting and removing key from ignition switch more than 6 times within 10 seconds. Hazard warning lights will flash to confirm.
- Turn ignition switch to ACC position. Push any button on new remote controller once. Identity code for new remote controller has now been entered. Hazard warning lights will flash to confirm.
- To enter additional remote controller identity code(s), lock, then unlock doors using door lock/unlock switch in power window main switch. Push any button on additional remote controller once. Hazard warning lights will flash to confirm. A maximum of 4 remote controller identity codes can be entered. If same identity code is entered more than once, the entry is ignored. To exit programming (identity entry) mode, unlock and open driver's door.