Remote Controller Id Set Up With Consult-II

NOTE: If a remote controller is lost, the ID code of the lost remote controller must be erased to prevent unauthorized use. When the ID code of a lost remote controller is not known, all controller ID codes should be erased. After all ID codes are erased, the ID codes of all remaining and/or new remote controllers must be re-registered.

Turn ignition switch "OFF".
Connect CONSULT-II to the data link connector.

Fig 1: Connecting CONSULT-II To Data Link Connector
Turn ignition switch "ON".
Touch "START".

Fig 2: Displaying START On Consult-II Screen
Touch "SMART ENTRANCE".

Fig 3: Displaying SMART ENTRANCE On Consult-II Screen
Touch "MULTI REMOTE ENT".

Fig 4: Displaying MULTI REMOTE ENT On Consult-II Screen
Touch "WORK SUPPORT".

Fig 5: Displaying WORK SUPPORT On Consult-II Screen
The items are shown on the figure at left can be set up.
"REMO CONT ID CONFIR"

Use this mode to confirm if a remote controller ID code is registered or not.

"REMO CONT ID REGIST"

Use this mode to register a remote controller ID code.

NOTE: Register the ID code when remote controller or smart entrance control unit is replaced, or when additional remote controller is required.

"REMO CONT ID ERASUR"

Fig 6: Displaying REMO CONT ID ERASUR On Consult-II Screen

Use this mode to erase a remote controller ID code.

"HZRD REM SET"

Use this mode to activate or deactivate the hazard and horn reminder.