Consult-II Inspection Procedure

Turn ignition switch OFF.
Connect CONSULT-II and CONSULT-II CONVERTER to data link connector.

Fig 1: Locating Data Link Connector
Courtesy of NISSAN MOTOR CO., U.S.A.
Turn ignition switch ON.
Turn ASCD main switch ON.
Touch START (NISSAN BASED VHCL) (on CONSULT-II display).
Touch ASCD.
If "ASCD" is not indicated, go to CONSULT-II DATA LINK CONNECTOR (DLC) CIRCUIT .

Fig 2: CONSULT-II Menu Screen
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch SELF-DIAG RESULTS.

Fig 3: Selecting SELF-DIAG RESULTS Menu
Courtesy of NISSAN MOTOR CO., U.S.A.
- Self-diagnostic results are shown on display
  Refer to CONSULT-II SELF-DIAGNOSTIC RESULTS .
Fig 4: Self-Diagnostic Results Display Screen
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch DATA MONITOR.

Fig 5: Selecting DATA MONITOR Menu
Courtesy of NISSAN MOTOR CO., U.S.A.
- Touch START.
- Data monitor results are shown on display
  Refer to CONSULT-II SELF-DIAGNOSTIC RESULTS .
  
  For further information, read the CONSULT-II Operation Manual .

Fig 6: Data Monitor Results on Display

Courtesy of NISSAN MOTOR CO., U.S.A.