"Multi Remote ENT"

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carry out CAN communication.

Turn ignition switch OFF.
Connect "CONSULT-II" to the data link connector.

Fig 1: Locating Data Link Connector
Courtesy of NISSAN MOTOR CO., U.S.A.
Turn ignition switch ON.
Touch "START (NISSAN BASED VHCL)".

Fig 2: Identifying CONSULT-II Display
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "BCM".
If "BCM" is not indicated, Refer to CONSULT-II DATA LINK CONNECTOR (DLC) CIRCUIT .

Fig 3: Identifying CONSULT-II Display
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "MULTI REMOTE ENT".

Fig 4: Identifying CONSULT-II Display
Courtesy of NISSAN MOTOR CO., U.S.A.
Select diagnosis mode.
"DATA MONOTOR", "ACTIVE TEST" and "WORK SUPPORT" are available.

Fig 5: Identifying CONSULT-II Display

Courtesy of NISSAN MOTOR CO., U.S.A.