Moon Roof Resetting
WARNING: This page is about a different car, the 2003 Lexus ES 300 and 2002 Lexus ES 300. However, it is still accessible from the selected car via links, so may be relevant.
- Reset the moon roof position when the battery negative (-) terminal is disconnected, when the moon roof component parts are replaced and also when the fuse is replaced.
- To reset the zero point for moon roof, push and hold the switch on the TILT UP side until the moon roof tilts all the way up and down a little automatically.
- Confirm One-Touch Side Open/Close and One-Touch Tilt Up/Down functions by pushing the switch briefly to the SLIDE-OPEN and TILT-UP sides.
- Reset the moon roof position when the moon roof does not stop at the fully closed position even if the auto close switch is operated.
- Push and hold the switch on the TILT UP/CLOSE side until the moon roof stops.
- Continue to push and hold the switch on the TILT UP/CLOSE side for 10 seconds or more. The moon roof will close to the fully closed position.
- Continue to push and hold the switch on the TILT UP/CLOSE side until the moon roof tilts all the way up and down a little automatically.
- Confirm One-Touch Side Open/Close and One-Touch Tilt Up/Down functions by pushing the switch briefly to the SLIDE-OPEN and TILT-UP sides.
NOTE:
When the battery negative (-) terminal is disconnected or PWR NO. 1 fuse is removed and also the fuse is exchanged due to the repair, the moon roof position memory is erased. After reconnecting the battery negative (-) terminal, make sure to reset the zero point. If the reset is not performed, the moon roof automatic operation will not function.