Rear View Camera Operation: Notes

When ignition switch is in ON or START position, power is supplied

• through 10A fuse (No. 51, located in the IPDM E/R)
• to back-up lamp relay terminals 1 and 3.

When A/T selector lever is in reverse position, power is supplied

• through back-up lamp relay terminal 2
• to TCM terminal 7.

Then, when back-up lamp relay is energized,

• from back-up lamp relay terminal 5
• to rear view camera control unit terminal 4.

Then, rear view camera control unit is sent camera ON signal

• through rear view camera control unit terminal 8
• to rear view camera terminal 1.

An image taken by rear view camera is sent

• through rear view camera terminals 3 and 4
• to rear view camera control unit terminals 10 and 9.

Then an image is sent

• through rear view camera control unit terminals 11 and 12
• to display unit terminals 4 and 15.

An image of rear view will be projected on the display.