Front Power Window Motor RH Circuit Check

1. Connect power window and door lock/unlock switch RH.
2. Turn ignition switch ON.
3. Check voltage between power window and door lock/unlock switch RH connector D105 terminals 8, 9 and ground.
   CONNECTOR TERMINALS REFERENCE CHART
   
   

   Connector	Terminals		Condition	Voltage (V) (Approx.)
   	(+)	(-)
   D105	9	Ground	UP	0
   			DOWN	Battery voltage
   	8		UP	Battery voltage
   			DOWN	0

   Fig 1: Checking Voltage Between Power Window And Door Lock/Unlock Switch RH Connector Terminals And Ground

   

OK or NG 

OK: GO TO 2.

NG: Replace power window and door lock/unlock switch RH. Refer to "REMOVAL AND INSTALLATION ".

1. Turn ignition switch OFF.
2. Disconnect front power window motor RH and power window and door lock/unlock switch RH.
3. Check continuity between power window and door lock/unlock switch RH connector D105 terminals 8, 9 and front power window motor RH connector D104 terminals 1, 2.

   8 - 2 : Continuity should exist. 

   9 - 1 : Continuity should exist. 

   Fig 2: Checking Continuity Between Door Lock/Unlock Switch And Front Power Window Motor Connector Terminals

   

OK or NG 

OK: Replace front power window motor RH. Refer to "FRONT DOOR GLASS AND REGULATOR ".

NG: Repair or replace harness.