Limit Switch Circuit Check Front RH

1. Turn ignition switch ON.
2. Check voltage between power window motor RH connector D105 terminal 15 and ground.
   CONNECTOR TERMINALS REFERENCE CHART
   
   

   Connector	Terminals		Condition	Voltage (V) (Approx.)
   	(+)	(-)
   D105	15	Ground	Front power window RH is between fully-open and just before fully-closed position (ON)	0
   			Front power window RH is between just before fully-closed position and fully-closed position (OFF)	5

   Fig 1: Checking Voltage Between Power Window Motor RH Connector D105 Terminal And Ground

   

OK or NG 

OK: Limit switch circuit is OK.

NG: GO TO 2.

1. Turn ignition switch OFF.
2. Disconnect front power window motor RH.
3. Turn ignition switch ON.
4. Check voltage between front power window motor RH connector D104 terminal 5 and ground.

   5 - Ground : Approx. 5V 

OK or NG 

OK: GO TO 3.

NG: GO TO  5.

Fig 2: Checking Voltage Between Front Power Window Motor RH Connector Terminal And Ground

1. Turn ignition switch OFF.
2. Check continuity between front power window motor RH connector D104 terminal 6 and ground.

   6 - Ground : Continuity should exist. 

OK or NG 

OK: Replace front power window motor RH. Refer to "FRONT DOOR GLASS AND REGULATOR ".

NG: GO TO 4.

Fig 3: Checking Continuity Between Front Power Window Motor RH Connector D104 Terminal And Ground

1. Disconnect power window and door lock/unlock switch RH.
2. Check continuity between front power window motor RH connector D104 terminal 6 and power window and door lock/unlock switch RH connector D105 terminal 3.

   6 - 3 : Continuity should exist. 

OK or NG 

OK: Replace power window and door lock/unlock switch RH. Refer to "REMOVAL AND INSTALLATION ".

NG: Repair or replace harness.

Fig 4: Checking Continuity Between Front Power Window Motor RH And Power Window And Door Lock/Unlock Switch RH Connector

1. Turn ignition switch OFF.
2. Disconnect power window and door lock/unlock switch RH.
3. Check continuity between power window and door lock/unlock switch RH connector D105 terminal 15 and front power window motor RH connector D104 terminal 5.

   15 - 5 : Continuity should exist. 

OK or NG 

OK: Replace power window and door lock/unlock switch RH. Refer to "REMOVAL AND INSTALLATION ".

NG: Repair or replace harness.

Fig 5: Checking Continuity Between Door Lock/Unlock Switch RH And Front Power Window Motor RH Connector