Front Axle Hub: Installation

HINT:

• Use the same procedures for the LH side and RH side.
• The procedures listed below are for the LH side.

1. INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH (for 2WD) 
   1. Apply MP grease to a new O-ring.
   2. Install the O-ring to the axle hub.
      NOTE: Do not damage the O-ring.
   3. Install the dust cover and axle hub to the steering knuckle with the 4 bolts.

      Torque: 99 N*m (1010 kgf*cm, 73 ft.*lbf) 

   Fig 1: Identifying Axle Hub Bolts
   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH (for 4WD) 
   1. Apply MP grease to a new O-ring.
   2. Install the O-ring to the axle hub.
      NOTE: Do not damage the O-ring.
   3. Connect the front drive shaft to the front axle hub.
      NOTE: Be careful not to damage the front drive shaft boot.
   4. Install the dust cover and axle hub to the steering knuckle with the 4 bolts.

      Torque: 99 N*m (1010 kgf*cm, 73 ft.*lbf) 

      Fig 2: Identifying Axle Hub Bolts

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. INSTALL FRONT AXLE HUB NUT LH (for 4WD) 
   1. Install the nut, front wheel adjusting lock cap and a new cotter pin.

      Torque: 338 N*m (3446 kgf*cm, 249 ft.*lbf) 

   Fig 3: Identifying Cotter Pin
   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. INSPECT FRONT AXLE HUB 
   1. Inspect the front axle hub (see ON-VEHICLE INSPECTION  ).
5. INSTALL FRONT AXLE HUB GREASE CAP LH (for 4WD) 
   1. Install the axle hub grease cap.
      NOTE: Make sure to securely fit the bearing to the axle hub.
6. INSTALL FRONT DISC LH  (See INSTALLATION )
7. CONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH 
   1. Connect the front disc brake caliper and install 2 new bolts.

      Torque: 99 N*m (1010 kgf*cm, 73 ft.*lbf) 

      Fig 4: Identifying Front Disc Brake Caliper Bolts

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      • Do not twist the flexible hose.
      • Make sure that the bolts are free from damage and foreign matter.
      • Do not overtighten the bolts.
   2. Connect the brake tube bracket to the steering knuckle with the bolt.

      Torque: 29 N*m (296 kgf*cm, 21 ft.*lbf) 

      Fig 5: Identifying Brake Tube Bracket

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
8. INSTALL FRONT WHEEL 

   Torque: for Aluminum Wheel 

   131 N*m (1336 kgf*cm, 97 ft.*lbf) 

   for steel Wheel 

   209 N*m (2131 kgf*cm, 154 ft.*lbf) 

9. CHECK SPEED SENSOR SIGNAL 
   1. Check the speed sensor signal (see TEST MODE PROCEDURE ).