Intake Valve Timing Control Solenoid Valve

Check resistance between intake valve timing control solenoid valve terminals as follows.

RESISTANCE SPECIFICATION CHART

Terminals	Resistance
1 and 2	7.1 - 7.7Ω [at 20°C (68°F)]
1 or 2 and ground	∞Ω (Continuity should not exist)

Fig 1: Checking Resistance Between Intake Valve Timing Control Solenoid Valve Terminals

Courtesy of NISSAN MOTOR CO., U.S.A.

If NG, replace intake valve timing control solenoid valve. Refer to INTAKE VALVE TIMING CONTROL .

If OK, go to next step.

Remove intake valve timing control solenoid valve. Refer to INTAKE VALVE TIMING CONTROL .
Provide 12V DC between intake valve timing control solenoid valve terminals and then interrupt it. Make sure that the plunger moves as shown in the figure.

Fig 2: Checking Plunger Movement
Courtesy of NISSAN MOTOR CO., U.S.A.

CAUTION: Do not apply 12V DC continuously for 5 seconds or more. Doing so may result in damage to the coil in intake valve timing control solenoid valve.

If NG, replace intake valve timing control solenoid valve. Refer to INTAKE VALVE TIMING CONTROL .

NOTE: Always replace O-ring when intake valve timing control solenoid valve is removed.