LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2009 >> M35 Base >> Repair and Diagnosis >> General Information >> Reset Procedures >> Tire Pressure Monitor Systems >> TPMS Reset Procedures >> Tire Pressure Sensor Registration >> ID Registration Without Transmitter Activation Tool
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

ID Registration Without Transmitter Activation Tool

  1. With the ignition switch in OFF position, connect CONSULT-II and CONSULT-II CONVERTER to the Data Link Connector (DLC). Turn ignition switch to ON position.
  2. Select "START (NISSAN BASED VHCL)".
  3. Select "AIR PRESSURE MONITOR" on "SELECT WORK ITEM" screen.
    NOTE: This screen display may not appear just after starting engine or turning ignition switch to ON position. In this case, reconnect CONSULT-II and CONSULT-II CONVERTER.
  4. Select "WORK SUPPORT" on "SELECT DIAG MODE" screen, and select "ID REGIST".
  5. Adjust the tire pressure to the specified values for ID registration, and drive the vehicle at 25 mph (40 km/h) or more for a few minutes. See ID Registration Tire Pressure Specifications (2003-04)  or ID Registration Tire Pressure Specifications (2006)  table.
    ID Registration Tire Pressure Specifications (2003-04)

    Tire Position Tire Pressure - psi (kPa)
    Front Left 36 (250)
    Front Right 33 (230)
    Rear Right 30 (210)
    Rear Left 27 (190)
    ID Registration Tire Pressure Specifications (2006-10)

    Tire Position Tire Pressure - psi (kPa)
    Front Left 34 (240)
    Front Right 31 (220)
    Rear Right 29 (200)
    Rear Left 26 (180)
  6. After completing all ID registrations, press "END" to complete the procedure.
  7. Inflate all tires to specification.
scientia non olet · About LEMON Manuals