Active Test
WARNING: This page is about a different car, the 2008 Infiniti M45 and 2008 Infiniti M35. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Can be tested only when swivel actuator initialization is completed. If initialization is not completed, "RETRY COMMAND" is displayed and cannot be tested.
- LOW BEAM TEST RIGHT
Low beam headlamp (right) can be operated to swivel angle 0° by touching "ORIGIN", and to maximum angle by "PEAK".
LOW BEAM TEST RIGHT CHARTTest Item Swivel Speed Mode ORIGIN/PEAK - FAST Three times fast as SLOW Normal operation ORIGIN/PEAK SLOW - Initialization - LOW BEAM TEST LEFT
Low beam headlamp (left) can be operated to swivel angle 0° by touching "ORIGIN", and to maximum angle by "PEAK".
LOW BEAM TEST LEFT CHARTTest Item Swivel Speed Mode ORIGIN/PEAK - FAST Three times fast as SLOW Normal operation ORIGIN/PEAK - SLOW - Initialization - LEVELIZER TEST
Aiming motor drive signal can be changed to approx. 85% (ratio to IGN power supply) by touching "ORIGIN", and to approx. 15% by "PEAK". That angles headlamp LO up and down.
LEVELIZER TEST CHARTTest Item Aiming Motor Drive Signal Light Axis (Reference Value) Ratio to IGN power supply Voltage ORIGIN Approx. 85% Approx. 10.6 V 0° PEAK Approx. 15% Approx. 1.9 V Approx. 2.5° (Relatively lower than that of origin)