Check Unlock Sensor
WARNING: This page is about a different car, the 2008 Infiniti FX45 and 2008 Infiniti FX35. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK UNLOCK SENSOR POWER SUPPLY
Check voltage between Intelligent Key unit connector and ground.
Courtesy of NISSAN MOTOR CO., U.S.A.
UNLOCK SENSOR POWER SUPPLYConnector Terminals (Wire color) Condition Voltage (V) (Approx.) (+) (-) M34 28 (W/B) Ground Driver side door lock is locked 5 Driver side door lock is unlocked 0 OK or NG
OK: Unlock sensor is OK.
NG: GO TO 2.
- CHECK UNLOCK SENSOR CIRCUIT
- Turn ignition knob LOCK position.
- Disconnect Intelligent Key unit and front door lock assembly (driver side) connector.
- Check continuity between Intelligent Key unit connector M34 terminal 28 (W/B) and front door lock assembly (driver side) connector D10 terminal 4 (W).
28 (W/B) - 4 (W) : Continuity should exist.
OK or NG
OK: GO TO 3.
NG: Repair or replace harness between Intelligent Key unit and front door lock assembly (driver side).
- CHECK UNLOCK SENSOR GROUND CIRCUIT
Check continuity between front door lock assembly (driver side) connector D10 terminal 5 (B) and ground.
5 (B) - Ground : Continuity should exist.
Courtesy of NISSAN MOTOR CO., U.S.A.
OK or NG
OK: GO TO 4.
NG: Repair or replace harness.
- CHECK INTELLIGENT KEY UNIT OUTPUT SIGNAL
- Connect Intelligent Key unit connector.
- Driver side door lock is locked.
- Check voltage between Intelligent Key unit connector M34 terminal 28 (W/B) and ground.
28 (W/B) - Ground : Approx. 5V
OK or NG
OK: Replace front door lock assembly (driver side).
NG: Replace Intelligent Key unit.