Disassembly And Assembly: MAINSHAFT: Assembly

WARNING: This page is about a different variant/trim than selected.

Install needle bearing to mainshaft.
CAUTION: Apply transfer fluid to periphery of needle bearing.
Install sprocket and electric controlled coupling to mainshaft.
Install spacer to main shaft.

Fig 1: Identifying Needle Bearing
Courtesy of NISSAN MOTOR CO., U.S.A.
Install snap ring (1) to mainshaft.
CAUTION: Never reuse snap ring.
Install mainshaft assembly to rear case, then install front case and rear case. Refer to "ASSEMBLY ".

Fig 2: Identifying Snap Ring
Courtesy of NISSAN MOTOR CO., U.S.A.