July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

DTC Confirmation Procedure

PRECONDITIONING-I
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.
  TESTING CONDITION:
  
  Before performing the following procedure, confirm that battery voltage is between 10 V and 16 V at idle.
  
  GO TO 2.
PRECONDITIONING-II
Check oil level and oil pressure. Refer to "INSPECTION ".

Is the inspection result normal?

YES: GO TO 3.

NO: Go to "INSPECTION ".

PERFORM DTC CONFIRMATION PROCEDURE

Select "DATA MONITOR" mode with CONSULT-III.

Maintain the following conditions for at least 20 consecutive seconds.

ENGINE SPEED REFERENCE CHART

ENG SPEED	More than 1, 700 rpm
COOLAN TEMP/S	More than 70°C (158°F)
Selector lever	1st or 2nd position
Driving location	Driving vehicle uphill (Increased engine load will help maintain the driving conditions required for this test.)

CAUTION: Always drive at a safe speed.

Check 1st trip DTC.
Is 1st trip DTC detected?

YES: Go to "DIAGNOSIS PROCEDURE "

NO: INSPECTION END