Diagnosis Procedure
WARNING: This page is about a different car, the 2011 Nissan Juke. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK IPDM E/R SELF-DIAGNOSTIC RESULT
- Turn ignition switch ON.
- Erase the DTC of IPDM E/R.
- Turn ignition switch OFF.
- Turn ignition switch ON and check the DTC again.
Is DTC detected?
YES: Repair or replace the malfunctioning part. Refer to , "DTC INDEX ".
NO: GO TO 2.
- CHECK IGNITION RELAY (IPDM E/R) CONTROL SIGNAL
- Turn ignition switch OFF.
- Check voltage between IPDM E/R harness connector and ground.CONNECTOR TERMINALS VOLTAGE REFERENCE CHART
(+) (-) Condition Voltage (V) (Approx.) IPDM E/R Connector Terminal E17 68 Ground Ignition switch OFF or ACC 12 Is the inspection result normal?
YES: Replace IPDM E/R.
NO: GO TO 3.
- CHECK IGNITION RELAY (IPDM E/R) CONTROL SIGNAL CIRCUIT - 1
- Turn ignition switch OFF.
- Disconnect BCM and IPDM E/R connectors.
- Check continuity between IPDM E/R harness connector and ground.CONNECTOR TERMINALS CONTINUITY REFERENCE CHART
IPDM E/R Ground Continuity Connector Terminal E17 68 Not existed Is the inspection result normal?
YES: GO TO 4.
NO: Repair or replace harness.
- CHECK IGNITION RELAY (IPDM E/R) CONTROL SIGNAL CIRCUIT - 2
- Connect IPDM E/R connectors.
- Check voltage between IPDM E/R harness connector and ground.CONNECTOR TERMINALS VOLTAGE REFERENCE CHART
(+) (-) Condition Voltage (V) (Approx.) IPDM E/R Connector Terminal E17 68 Ground Ignition switch OFF or ACC 12 Is the inspection result normal?
YES: Replace BCM. Refer to "REMOVAL AND INSTALLATION ".
NO: Replace IPDM E/R.