LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2010 >> M35 Base >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> Engine Control System - System And Component Testing >> Fuel Pump >> Component Inspection (Dropping Resistor)
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Component Inspection (Dropping Resistor)

  1. CHECK DROPPING RESISTOR
    1. Turn ignition switch OFF.
    2. Disconnect dropping resistor harness connector.
    3. Check resistance between dropping resistor as follows.
      TERMINAL RESISTANCE CHART

      Terminals Resistance
      1 and 2 0.9 Ω [at 20°C (68°F)]

      Is the inspection result normal? 

      YES: INSPECTION END

      NO: Replace dropping resistor.

      Fig 1: Checking Resistance Between Dropping Resistor Terminals 1 And 2
      G05210211Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals