Calibration Of DECEL G Sensor

WARNING: This page is about a different car, the 2011 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

To calibrate decel G sensor, make sure to use CONSULT. (Calibration cannot be done without CONSULT.)
Perform the G sensor calibration only with the vehicle parked on level surface.

ALIGN THE VEHICLE STATUS
Stop the vehicle with front wheels in straight-ahead position.
CAUTION:
- Keep all tires inflated to correct pressures. Adjust the tire pressure to the specified pressure value.
- Check that there is specified-load in vehicle other than the driver (or equivalent weight placed in driver's position).
GO TO 2.
PERFORM THE CALIBRATION OF DECEL G SENSOR
1. Select "ABS", "WORK SUPPORT" and "DECEL G SEN CALIBRATION" in order with CONSULT.
2. Select "START".
3. After approximately 10 seconds, select "END".
  NOTE: After approximately 60 seconds, it ends automatically.
4. Turn the ignition switch OFF, then turn it ON again.
  CAUTION: Be sure to perform above operation.
  
  GO TO 3.
CHECK DATA MONITOR
1. Run the vehicle with front wheels in straight-ahead position, then stop.
2. Select "ABS", "DATA MONITOR" and "DECEL G-SEN" in order with CONSULT, and check decel G sensor signal.
  DECEL G-SEN : ±0.08 G
  
  Is the yaw rate/side/decel G within the specified range?
  
  YES: GO TO 4.
  
  NO: Perform the calibration of decel G sensor again, GO TO 1.
ERASE THE SELF-DIAGNOSIS MEMORY
Erase the self-diagnosis memories for "ABS" with CONSULT. Refer to "CONSULT FUNCTION ".

Are the memories erased?

YES: INSPECTION END

NO: Check the items indicated by the self-diagnosis.