April 5, 2026: LEMON Manuals is launched! Read the announcement.

Component Function Check

INSPECTION START
Turn ignition switch OFF, and restart engine.

Does the engine start?

YES-1: With CONSULT: GO TO 2.

YES-2: Without CONSULT: GO TO 3.

NO: Go to "DIAGNOSIS PROCEDURE ".
CHECK IGNITION SIGNAL FUNCTION
WITH CONSULT
1. Perform "POWER BALANCE" in "ACTIVE TEST" mode with CONSULT.
2. Check that each circuit produces a momentary engine speed drop.
Is the inspection result normal?

YES: INSPECTION END

NO: Go to "DIAGNOSIS PROCEDURE ".

CHECK IGNITION SIGNAL FUNCTION

WITHOUT CONSULT

Let engine idle.
Read the voltage signal between ECM harness connector terminals under the following conditions with an oscilloscope.

ECM					Voltage signal
Cylinder	+		-
Cylinder	Connector	Terminal	Connector	terminal
1	F111	12	E80	175	Courtesy of NISSAN NORTH AMERICA, INC.
2		13
3		14
4		15
5		17
6		18
7		19
8		20

NOTE: The pulse cycle changes depending on rpm at idle.

Is the inspection result normal?

YES: INSPECTION END

NO: Go to "DIAGNOSIS PROCEDURE ".