LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2013 >> FX37 Base, AWD >> Repair and Diagnosis >> General Information >> Reset Procedures >> Tire Pressure Monitor Systems >> TPMS Reset Procedures >> Tire Pressure Sensor Registration >> ID Registration With Transmitter Activation Tool
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

ID Registration With Transmitter Activation Tool

  1. With the ignition switch in OFF position, connect CONSULT-III to the Data Link Connector (DLC).
  2. Turn ignition switch to ON position.
  3. Display the "WORK SUPPORT" screen and select "ID REGIST". Select "START " on the "ID REGIST" screen.
  4. With the Transmitter Activation Tool (J-45295) pushed against the front left tire transmitter/air valve, press the button for 5 seconds. See Fig 1.
  5. Register the IDs in the specified order. See ID REGISTRATION ORDER SPECIFICATIONS  table. When ID registration of each wheel has been completed, the turn signal lights blink.
    ID Registration Order Specifications

    Tire Position Turn Signal Will Flash CONSULT-III
    Front Left 2 Times From RED
    To GREEN
    Front Right 2 Times From RED
    To GREEN
    Rear Right 2 Times From RED
    To GREEN
    Rear Left 2 Times From RED
    To GREEN
    NOTE: Be sure to register the IDs in the specified order, or the self-diagnostic results display will not function properly.
  6. After completing all ID registrations, press "END" to complete the procedure.
Fig 1: Identifying Transmitter Activation Tool (J-45295)
G00225482Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals