LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2013 >> M35h >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Brake System) >> DTC/Circuit Diagnosis >> DTC C1A6A: Control Module >> DTC Logic >> DTC Confirmation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2012 Infiniti M35h. However, it is still accessible from the selected car via links, so may be relevant.
  1. PRECONDITIONING

    If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

    : GO TO 2.

  2. CHECK DTC DETECTION

    ◦ With CONSULT-III.

    1. Turn the ignition switch OFF to ON.
      CAUTION: Never set the vehicle to READY/Never start the engine.
    2. Repeat step  1 two times or more.
      CAUTION: Be sure to wait for 5 seconds or more after turning the ignition switch OFF.
    3. Turn the ignition switch OFF.
    4. Close all doors including the trunk lid, and wait outside of vehicle for 5 minutes or more.
    5. Turn the ignition switch ON.
      CAUTION: Never set the vehicle to READY/Never start the engine.
    6. Erase self-diagnosis result of "BRAKE".
      CAUTION: Turn the ignition switch OFF and wait 5 minutes or more after erase self-diagnosis result.
    7. Depress brake pedal by 100 mm (3.94 in) or more, and hold the position for 5 seconds or more.
    8. Release brake pedal.
    9. Repeat steps  7 to  8 three times.
    10. Perform "BRAKE" self-diagnosis.

      Is DTC "C1A6A" detected? 

      YES: Proceed to "DIAGNOSIS PROCEDURE ".

      NO: INSPECTION END

scientia non olet · About LEMON Manuals