Ignition Battery Saver System
When all the following conditions are met for 30 minutes, the battery saver system will cut off the power supply (ignition switch position ACC/ON → OFF) to prevent battery discharge.
- Ignition switch is in the ACC/ON position
- Turn signal lamp is not in operation
- Selector lever is in the P position
NOTE:
For one minute after thirty minutes have passed or three minutes after twenty-seven minutes are passed, the following display is indicated on information display in combination meter and sounds buzzer in combination meter.
| Combination meter | Time | |
|---|---|---|
| Information display | Buzzer | |
| Power turned off to save the battery | Pipi-Pipi (two seconds) | For one minute after thirty minutes have passed |
| three minutes after twenty-seven minutes are passed | ||
Reset Condition of Ignition Battery Saver System
If any of the following conditions are met the battery saver system is released.
- Ignition switch is not in the ACC/ON position
- Turn signal lamp is in operation
- Selector lever is not in the P position
NOTE:
The ignition battery saver system can be temporarily disabled, without using CONSULT, to prevent it from functioning when performing trouble diagnosis. Refer to
"WORK PROCEDURE ".