FOR MEXICO: Work Procedure

Check DTC.

Is any DTC detected? 

YES: Repair malfunction(s) and erase DTC. Refer to "DTC INDEX ".

NO: GO TO 2.

With CONSULT

Select "SRT STATUS" in "DTC & SRT CONFIRMATION" mode using CONSULT.

With GST

Select Service $01 with GST.

Is SRT code(s) set? 

YES: END

NO-1: With CONSULT: GO TO 3.

NO-2: Without CONSULT: GO TO  4.

1. Select "SRT WORK SUPPORT" in "DTC & SRT CONFIRMATION" mode using CONSULT.
2. For SRT(s) that is not set, perform the corresponding DTC confirmation procedure according in the SRT ITEM" table. Refer to "FOR MEXICO: DESCRIPTION ".
3. Check DTC.

   Is any DTC detected? 

   YES: Repair malfunction(s) and erase DTC. Refer to "DTC INDEX ".

   NO: GO TO  9.

• Check the SRT ITEM table. Refer to "FOR MEXICO: DESCRIPTION ".
• Perform the most efficient SRT set driving pattern. Refer to "FOR MEXICO: SRT SET DRIVING PATTERN ".

  In order to set all SRTs, the SRT set driving pattern must be performed at least once.

  : GO TO 5.

1. Check the vehicle condition;
   • Engine coolant temperature is -10 to 35°C (14 to 95°F).
   • Fuel tank temperature is more than 0°C (32°F).
2. Perform INSPECTION MODE 5. Refer to "DESCRIPTION ".
3. Start the engine.
4. Keep engine idling until the engine coolant temperature is greater than 70°C (158°F)
   NOTE: ECM terminal voltage is follows;

   • Engine coolant temperature
     • -10 to 35°C (14 to 95°F): 3.0 - 4.3 V
     • 70°(158°F): Less than 1.4 V
   • Fuel tank temperature: Less than 4.1 V

   Refer to "REFERENCE VALUE ".

   : GO TO 6.

1. Drive the vehicle. And depress the accelerator pedal until vehicle speed is 90 KM/H (56 MPH), then release the accelerator pedal and keep it released for more than 10 seconds.
2. Depress the accelerator pedal until vehicle speed is 90 KM/H (56 MPH) again
   NOTE:

   • Checking the vehicle speed with GST is advised.
   • When steady-state driving is performed again even after it is interrupted, each diagnosis can be conducted. In this case, the time required for diagnosis may be extended.

   : GO TO 7.

• Operate vehicle following the driving pattern shown in the figure below.
• Release the accelerator pedal during deceleration of vehicle speed from 90 KM/H (56 MPH) to 0 KM/H (0 MPH).

  : GO TO 8.

  Fig 1: Vehicle Driving Pattern 3

  Courtesy of NISSAN NORTH AMERICA, INC.

• The accelerator pedal must be held very steady during steady-state driving.
• If the accelerator pedal is moved, the test must be conducted again.

  : GO TO 9.

With CONSULT

Select "SRT STATUS" in "DTC & SRT CONFIRMATION" mode using CONSULT.

With GST

Select Service $01 with GST.

Is SRT(s) set? 

YES: END

NO: Call TECH LINE or take appropriate action.