Precautions For Harness Repair

Solder the repaired area and wrap tape around the soldered area.

Fig 1: Identifying Soldered And Taped Repair Area
Courtesy of NISSAN NORTH AMERICA, INC.

NOTE:
A fray of twisted lines must be within 110 mm (4.33 in).
Bypass connection is never allowed at the repaired area.

Fig 2: Identifying Improper Bypass Connection
Courtesy of NISSAN NORTH AMERICA, INC.

NOTE:
Bypass connection may cause CAN communication error. The spliced wire becomes separated and the characteristics of twisted line are lost.
Replace the applicable harness as an assembly if error is detected on the shield lines of CAN communication line.