Work Procedure

WARNING: This page is about a different car, the 2015 Infiniti Q70. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Check that the "HV BATTERY LEVEL" in "DATA MONITOR" mode of "EV/HEV" using CONSULT is 50% or more, or else use the "Li-ion battery state of charge" in the information display on the combination meter and check that the battery level is 50% or more.
Check that the engine coolant temperature is 70 °C (158 °F) or more before using inspection mode 1.

PERFORM CLUTCH 1 POSITION LEARNING

WITH CONSULT:
1. Turn ignition switch ON.
2. Select "CLUTCH 1 POSITION LEARNING" in "WORK SUPPORT" mode of "EV/HEV" using CONSULT.
3. Clear clutch 1 position learning value by touching "START".
4. Set the vehicle to READY.
5. Shift the selector lever position N and check that an engine stops.
6. Fully depress accelerator pedal and start an engine.
7. Fully release accelerator pedal and stop an engine.
8. Repeat step 6 and 7 for 20 times.
CAUTION:
Never turn ignition switch OFF during step 1 to 8.

When ignition switch is turned OFF, start again from step 1.

END