Work Procedure: FPCM

WARNING: This page is about a different car, the 2018 Infiniti Q60. However, it is still accessible from the selected car via links, so may be relevant.

PERFORM CONFIGURATION
With CONSULT
1. Turn ignition switch ON.
2. Select the "Re/programming, Configuration" of CONSULT.
3. Perform configuration according to the CONSULT display.
GO TO 2.
WRITING MODE SELECTION
CONSULT Configuration

Select "CONFIGURATION" of FSCM.

When writing saved data

GO TO 3.
PERFORM "Before ECU Replacement"
CONSULT Configuration

Select "Before ECU Replacement". (If necessary)

GO TO 4.
PERFORM "Before ECU Replacement"
CONSULT Configuration

Perform "Before ECU Replacement" according to the CONSULT display. (If necessary)

GO TO 5.
PERFORM CONFIGURATION
With CONSULT
1. Turn ignition switch ON.
2. Select the "Re/programming, Configuration" of CONSULT.
3. Select the "After ECU Replacement".
4. Select the "Manual Configuration". (If necessary)
5. Confirm and/or change setting value for each item.
6. Perform configuration according to the CONSULT display.
GO TO 6.
CHECK DTC
With CONSULT
1. Turn ignition switch OFF and wait for 10 seconds or more.
2. Turn ignition switch ON.
3. Perform self-diagnosis.
4. Check that no DTC is detected.
WORK END