Work Procedure

WARNING: This page is about a different variant/trim than selected.

SAVING DATA
With CONSULT
1. Turn the ignition switch OFF to ON.
2. Select "SAVING DATA FOR REPLC CPU" in "WORK SUPPORT" for "ALL MODE AWD/4WD".
3. Select "Start".
4. Check that "Completed" is displayed.
GO TO 2.
PERFORM REPLACING AWD CONTROL UNIT
Replace AWD control unit. Refer to Removal and Installation .

GO TO 3.
WRITING DATA
With CONSULT
1. Turn the ignition switch OFF to ON.
2. Select "WRITING DATA FOR REPLC CPU" in "WORK SUPPORT" for "ALL MODE AWD/4WD".
3. Select "Start".
4. Check that "Completed" is displayed.
WORK END